Om man er virkelig kreativ, har god tid, og har litt fra Kawasaki, DKW, Yamaha, Suzuki, Matchless og Ford er det utrolig hva man klarer å sette sammen.

Robert Harms har tydeigvis mye av alt, og resultatet er denne ”Indian-Kawasaki” som kan minne om et byggesett fra Lego.

Sykkelen har utrolig mye detaljer, og en oppdager noe nytt hver gang man ser på bidene. Blant annet er det en Airbag (fra Ford) montert der tanken normalt sitter. Baklykten er montert i en sylinderhode.

indiankawasaki_1240380504.jpg

indiankawasaki2_1240380560.jpg

Robert Harm forklarer selv følgende:
All [of my] bikes are fully functional and thoroughly tested. NOTHING is done for appearance only. Nothing is a shortcut because its a show bike as none of them are shown or displayed. All lights work, they start and stop and the dimensionality and ergonomics are correct and realistic.

indiankawasaki6_1240380616.jpgEssentially all parts are either made, adapted or extensively modified. Nothing other than hardware comes off the end of a UPS truck. Parts are predominantly cheap and come from a multiplicity of sources and did not necessarily begin their existence on donor motorcycles.

This bike was the least planned in a series of unplanned bikes. I had purchased several new 2007 Kawasaki KLR 650s that had been in a warehouse fire. After assembling one for my use and parting out two others I was left with a complete new smoke damaged motor. I also had a 49 Indian Scout plunger frame and a DKW Earles front end in the to-be-used-someday pile.

When I began I had a vague idea of a Scout with the KLR and the DKW front end. It progressed from that point in a 10 month series of twists and turns.

The frame was modified to accept the KLR but it became immediately apparent that the tall KLR was not only too high but water cooled both of which presented design strictures.

After the aforementioned starts and stops and dead ends, the frame was modified to accept the motor by removing the center backbone tube and replacing it with paired of siamesed tubes that carry the water to and from the side mounted Suzuki radiator. The frame was later converted to swing arm after the OEM Indian plunger rear was welded solid, exorcised from the frame and converted to a swinging section using a KLR rear swingarm pivot. The rear wheel (Yamaha Seca 19″ front) uses GSXR brakes The rear swingarm (Indian) box assy is now controlled by the sole HD shock which is mounted laterally under the seat. The DKW front end was widened to accept the Seca wheel with GSXR brakes and converted to a leaf spring suspension using a modified trailer spring. The front shocks are fabricated Houdaille style friction units.

The small tank at the top of the frame is the water circulation tank built from a cast aluminum omelet pan sourced from eBay. The rear gas tank (Indian camelback style) was made from sheet aluminum and TIG welded. The toolbox door was originally a derby cover from a damaged 101 Scout primary cover. The actual toolbox , like the headlight (turned from a cast aluminum saucepan) and most other parts were made on site. You may also note the piston taillight (real piston) and the 1927 Matchless shift gate and the dimensionally shrunk Dawes cast tractor seat.

indiankawasaki3_1240380642.jpg

indiankawasaki4_1240380666.jpg

indiankawasaki5_1240380687.jpg

Meld deg på vårt Nyhetsbrev

Følg oss